Polystyrene performance and process characteristics

PS (polystyrene)

1 .PS Performance: PS is an amorphous polymer, good liquidity, low water absorption (less than 00.2%), is an easy molding of transparent plastic. Its products light transmission rate of 88-92%, tinting strength and high hardness. But PS products brittleness, easy to produce stress cracking, about poor heat resistance (60-80 ℃), non-toxic, the proportion of 1.04g \ cm3 (slightly larger than water). Molding shrinkage (typical value 0.004-0.007in / in), it represents only the name PS– transparent transparency of the resin, but not the degree of crystallinity. (Chemical and physical properties: Most commercial use PS are transparent, non-crystalline material .PS have very good geometric stability, thermal stability, optical transmission properties, electrical insulating properties and very small hygroscopic tendency it. resistant to water, diluted mineral acids, but can be strong oxidizing acids such as concentrated sulfuric acid corrosion and is capable of expansion and deformation in some organic solvent.)

mxcpPacking-peanuts

2 .PS process characteristics: PS melting point of 166 ℃, the processing temperature is generally 185-215 ℃ appropriate, the melting temperature of 180 ~ 280 ℃, flame-retardant materials for the upper limit is 250 ℃, decomposition temperature of about 290 ℃, so a wide range of processing temperature. Mold temperature 40 ~ 50 ℃, injection pressure: 200 ~ 600bar, injection speed is recommended to use a fast injection speed, runners and gates can be used for all conventional types of gate. PS material prior to processing, unless stored properly, usually it does not require drying. If required, it recommended drying conditions for 80C, 2 ~ 3 hours. Due to low specific heat, the heat that is able to make some mold condensation cured quickly, the cooling rate is faster than the average raw material, molding time can be earlier. Plasticizing time and cooling time is shorter molding cycle time will reduce the number; PS products with gloss mold temperature increases, the better.

3. Typical Applications: packaging products (containers, covers, bottles), disposable medical supplies, toys, cups, knives, tape reels, storm windows and many foam products – egg and fish boxes. Meat and poultry packaging tray, bottle labels and EPS foam cushioning materials, product packaging, household items (dishes, trays, etc.), electrical (transparent container, light scattering, insulation film, etc.).

This entry was posted in What is EPS and tagged , , , , . Bookmark the permalink.

Leave a Reply